OTHER WATERJET HIGH PRESSURE COIL TUBE

Robotic water cutting high-pressure water system: ultra-high pressure intensifier pump

The ultra-high-pressure intensifier pump is the core of robotic waterjet cutting. There are many requirements for the installation and use of the intensifier pump. Let's take a look at what kind of environment can extend the service life of the intensifier pump.
Environmental requirements:
1: Factory temperature.

The operating temperature range of the water cutting  pump is: 5°-30°, and the relative humidity is 30%-80%RH. The water temperature of the water cutting booster pump is generally above 20°. The pump has protection and Alarm device. If the working water temperature is lower than 20°C, the  pump will stop working and even cannot be started. This is a conventional protective device, because if the water temperature is too low, various seals inside the booster pump will be damaged. Therefore, it is recommended that customers heat the water temperature to above 20°.

2: Atmospheric pressure and air quality

The atmospheric pressure is 86Kpa-106Kpa, the dust concentration in the air must not be greater than 10mg/m3, and must not contain acid, salt and corrosive gases. Gases corrode steel and will cause steel to rust and rot. More importantly, when the air Too much moisture and corrosiveness will corrode the circuit of the water cutting booster pump. When the circuit problem occurs, it is a very troublesome matter. WINWIN company took this into consideration and made the circuit and electrical box waterproof and moisture-proof when designing it. The design effectively ensures the dryness inside the control cabinet and electrical box, and avoids many equipment malfunctions.

3: The equipment should be kept away from earthquake sources, heat sources, interference sources and heat flows, and its vibration in the workshop should be below 0.5G (G is the acceleration of gravity). Interference sources and magnetic fields will interfere with the normal operation of the  pump. Some parts of the water cutting booster pump have magnetic fields during operation. When the surrounding magnetic field is too large, it will interfere with the booster pump itself when it is working. signal, causing the booster pump reversal to malfunction. This fault itself does not lie in the  pump, but is caused by the surrounding environment. Therefore, customers need to pay attention to this situation and do not blindly disassemble the booster pump and cause unnecessary losses. .

4: Foundation requirements: Strictly follow the foundation soil provided by the manufacturer for construction. Water cutting equipment works with vibration and resonance. When the robot water cutting express moves, the stress on the ground and fixing screws increases, so the foundation and fixing screws must follow the manufacturer's instructions. This is a very important aspect and I hope the technicians will verify it carefully.

5: Placement requirements: At least 900mm of clearance should be left on each side of the ultra-high voltage generator to facilitate maintenance. Replacing the wearing parts of the supercharger is something that every maintenance technician must do. The pump There are a variety of wearing parts that need to be replaced regularly. WINWIN will provide detailed training and demonstrations during the installation and debugging process for customers. There are corresponding teaching videos on the WINWIN official website. These ways will facilitate customers to understand and learn. You can Replace some common wearing parts by yourself to maintain the pump.

If you are looking for robot waterjet cutting system suppliers or Robotic Water jet Coils suppliers, as well as waterjet technical support needs related to water cutting, please feel free to contact us, we can provide free online support for you.